Life cycle data for process plant: Reference data for observations and measurements ISO/WD 15926-x:200x(E)
Cover page
Table of contents
Copyright
Foreword
Introduction
1Scope
2Normative references
3Terms, definitions, abbreviations and symbols
4Observations and measurements reference data
 4.1Introduction to observations and measurements reference data
 4.2Observing activity
 4.3Information
 4.4Temporal part and time
 4.5Variation of property
 4.6Monitoring activity
 4.7Monitoring criterion
AInformation object registration
BDocument URN
CReference data relationships
DReference data as OWL
ETemporal part example
Bibliography
Index

ISO TC184/SC4/WG3 N2537   Date: 2008-11-05

Supersedes n/a


ISO/WD 15926-x (E)
Industrial automation systems and integration —
Life cycle data for process plant —
Part x: Reference data for observations and measurements

COPYRIGHT NOTICE:
This ISO document is a Technical Specificiation and is copyright protected by ISO. Except as permitted under the applicable laws of the user's country, neither this ISO draft nor any extract from it may be reproduced, stored in a retrieval system or transmitted in any form or by any means, electronic, photocopying, recording, or otherwise, without written permission being secured

Requests for permission to reproduce this document should be addressed to ISO at the address below or ISO's member body in the country of the requestor:

ISO copyright office
Case postale 56, CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org

Reproduction for sales purposes may be subject to royalty payments or a licensing agreement. Violators may be prosecuted.

ABSTRACT:
This document specifies an ontology for describing a physical network. This ontology can be used by intelligent devices to publish information about their existence and state.

This ontology encompasses measurements made by sensors within a network and the storage and processing of measurements.

This ontology is intended to enable the use of inferencing to support activities carried out upon a network, including operations and maintenance.

KEYWORDS:
ontology, network, intelligent, sensor, measurement, inferencing, operations, maintenance

COMMENTS TO READER:
First working draft.

This document has been produced within the EU co-funded project Intelligent Self-describing Technical and Environmental Networks (S-TEN), contract nunber: FP6-027683. The contribution from the EU is gratefully acknowledged.
Project Leader: Magne Valen-Sendstad

Address:DNV
Veritasveien 1
1322 Høvik
Norway
Tel: +47 67 57 82 17
E-mail: magne.valen-sendstad@dnv.com
Project Editor: David Leal

Address: CAESAR Systems Limited
29 Somertrees Avenue
Lee, London, SE12 0BS
UK
Tel: +44 20 8857 1095
E-mail: david.leal@caesarsystems.co.uk


© ISO 200x — All rights reserved